Product Details:
Contact Now
Chat Now
|
New / Used: | Used | Frequency Range: | 100 KHz – 20 GHz (Option 520) |
---|---|---|---|
Frequency Resolution: | 0.01 Hz Standard (0.001 Hz With Fractional-N Opt 1ER/008) | SSB Phase Noise: | ≈ –120 DBc/Hz @ 10 GHz, 20 KHz Offset (typical) |
Calibrated Output Power: | +23 DBm To –144 DBm With Electronic Step Attenuator (Opt 1EA + 1E1) | Analog Modulation: | AM, FM, φM To 1 MHz Deviation; Wide-band Pulse To 50 KHz Rate |
Highlight: | 20 GHz Signal Generator Analog,MXG Signal Generator Analog,Agilent N5183A analog devices signal generator |
Attribute | Value |
---|---|
New / Used | Used |
Frequency Range | 100 kHz – 20 GHz (Option 520) |
Frequency Resolution | 0.01 Hz standard (0.001 Hz with fractional-N Opt 1ER/008) |
SSB Phase Noise | ≈ –120 dBc/Hz @ 10 GHz, 20 kHz offset (typical) |
Calibrated Output Power | +23 dBm to –144 dBm with electronic step attenuator (Opt 1EA + 1E1) |
Analog Modulation | AM, FM, φM to 1 MHz deviation; wide-band pulse to 50 kHz rate |
The pre-owned Agilent N5183A MXG sweeps from 100 kHz to 20 GHz while delivering a -120 dBc/Hz phase-noise floor and up to +23 dBm output, so it substitutes for crystal-clean local oscillators and drives power-amplifier compression from the same port. An electronic step attenuator furnishes a calibrated 167 dB span (+23 dBm to -144 dBm), eliminating external pads for receiver-sensitivity or EMC work. Built-in AM/FM/PM and pulse modulation plus list-mode frequency hopping accelerate device characterisation, and full SCPI control over LAN or GPIB drops straight into automated benches.
Refurbished units ship ISO-17025-calibrated with current firmware, trimming capital outlay and lead-time yet preserving Keysight reliability, option upgrade paths and long-term serviceability.
Interested in an Agilent N5183A or a similar model?
Every unit is calibrated at an ISO/IEC 17025 accredited laboratory. The original calibration certificate, marked TESTRO Certified, is linked to the unit's serial number and included in the shipment.
We accept T/T, wire transfer, credit card.
Customers are welcome to visit our Shenzhen warehouse and refurbishment line to inspect calibration benches, burn-in racks, and inventory.
Contact Person: Ben